The daily maintenance of the metal desktop CNC fiber laser cutting machine is very important. Correct maintenance of the metal stainless steel carbon steel CNC fiber laser cutting machine can help the metal stainless steel carbon steel CNC fiber laser cutting machine to better exert its superior cutting performance. The probability of failure in the process will also be reduced. How to carry out the daily maintenance of metal stainless steel carbon steel CNC fiber laser cutting machine?

1. Fill the linear guide rail with lubricating oil

The smoke and dust generated by the metal stainless steel carbon steel CNC fiber laser cutting machine for a period of time have a corrosive effect on the guide rail, so the guide rail should be regularly maintained. Turn off the power of the metal stainless steel carbon steel CNC fiber laser cutting machine, clean the guide rail with a clean soft cloth, and then drip lubricating oil on the guide rail. After applying the oil, let the slider roll back and forth on the guide rail to ensure that the lubricating oil enters the slide inside the block. After the oil is applied, let the slider roll back and forth on the guide rail. At this time, the guide rail must be installed first. Be careful not to fix the guide rail first. Install all the fixing nails and keep them horizontal. After fixing the belt and the slider, Then install the lens, adjust the light and finish the way of X direction.

2. Mirror focusing mirror wipe

Metal stainless steel carbon steel CNC fiber laser cutting machine | Metal stainless steel carbon steel CNC fiber laser cutting machine After a period of use, smoke and dust will adhere to the surface of the lens, affecting the engraving and cutting depth, as well as the engraving and cutting accuracy. Usually about a week (according to the frequency of use of metal stainless steel carbon steel CNC fiber laser cutting machine | engraving machine) carefully wipe three mirrors and one focusing mirror with anhydrous alcohol.

3. Oil the bearing

Metal stainless steel carbon steel CNC fiber laser cutting machine uses a large number of bearings. In order to ensure good cutting and engraving effects, some bearings need to be oiled regularly (except oil-containing bearings). The oil is sucked into the needle tube, and then slowly poured into the bearing with the needle, and the bearing can be slowly rotated during oil filling.

4. Belt (transmission belt) tightness adjustment

There are several synchronous belts in the transmission system of the metal stainless steel carbon steel CNC fiber laser cutting machine. If the synchronous belt is too loose, the engraved font will appear ghosting. If the synchronous belt is too tight, the synchronous belt will be worn. After using for a period of time, please adjust the tensioning screw of the synchronous belt, adjust the synchronous belt to a proper tightness, the engraved text will not appear ghosting, and the metal stainless steel carbon steel CNC fiber laser cutting machine, metal stainless steel carbon steel CNC fiber laser cutting machine It is advisable to operate with very low noise, or consult the manufacturer's technicians.

5. Laser maintenance

The laser in the metal stainless steel carbon steel CNC fiber laser cutting machine is cooled by circulating water. After long-term use, there will be some white scale in the pipe. We can add a small amount of vinegar to the circulating water to remove the water ditch in the pipe. Then use clean water to rinse the inside of the laser tube, so that the laser tube will be in the best working condition and its life will be extended.