Do you know all these problems and solutions about fiber laser cutting machine?

Q: How is the table for batch modification of parts in TubesT sorted? What are the methods for modifying the sorting?

A: Set the system of the fiber laser cutting machine not to break up the files, then select the files to be sorted and click ascending and descending to change the order of the file positions.

Q: Do I need to set segmented perforation in the HypCut intelligent perforation setting?

A: The Bochu 8000 system is equipped with a BLT6 series cutting head, and you can check intelligent perforation. Intelligent perforation means that the cutting head monitors the perforation process in real time through sensors during the perforation process. After the hole is penetrated, it immediately drops to the cutting height without extra waiting, which greatly improves the perforation efficiency, reduces the overall processing time, and reduces costs and increases efficiency. It has nothing to do with whether it is segmented or progressive. For example, if you set a three-level perforation, the three-level perforation has already penetrated the hole in the actual perforation. The sensor monitors and senses it and transmits the information to the software. The software no longer executes the second and first level perforations, but cuts when it drops to the cutting height.

Q: What do TubePro interpolation distance correction value, interpolation maximum upward speed, interpolation maximum downward speed, and interpolation follow level mean, and what is the basis for filling in the values?

A: Interpolation correction value: Under the premise of complete Z-axis control, the height controller is operated to follow within the range of ±N on the board surface. Interpolation maximum upward/downward speed: Within the range of interpolation follow, the maximum speed at which the height controller follows up and down. Interpolation follow level: refers to the speed of following. The higher the level, the more obvious the jitter.

Q: Why can't CypCut be put into the white workbench after layout? If it can't be put in, it will definitely not be cut?

A: The white frame is the effective cutting range of the machine tool. The graphics after layout are larger than the stroke of the machine tool, so it cannot be cut.

Q: Y-axis servo alarm, the servo is Fuji, the alarm code is RH1, the internal regenerative resistor is overheated, and a new servo is replaced, but the alarm still occurs?

A: The internal regenerative resistor is overheated: Check whether the servo has an external resistor. If there is no resistor, please connect the resistor and set the parameter of PA2-65 to 2 to confirm which servo alarm is for all or the fixed axis. If each axis alarms, you can measure whether the voltage is too high. If only the fixed axis servo alarms, you can check whether the mechanical friction coefficient of the axis is too high, such as reducer failure, slide oil shortage, gear rack too tight, etc. You can reduce the idling/cutting speed and reduce the acceleration of the machine tool.