Regarding the accuracy and speed control of the gantry CNC plasma cutting machine, through a lot of practice it can be seen that there is a mutual balance process. When the cutting speed is too fast, it will inevitably lead to insufficient cutting accuracy and uneven cutting surfaces. In turn, in order to ensure the cutting In order to improve the accuracy and quality of the cutting seam and surface, there will be an insurmountable upper limit for the setting of the cutting speed. So what aspects do users of cutting machine manufacturers need to pay attention to regarding the balance between speed and accuracy of CNC plasma cutting machines?

First point, cutting accuracy:

For those used in the construction industry, the general requirement is less than 0.5mm; but for automotive reflective products, the requirement is less than 0.01m. The cutting requirements for steel plate processing are as low as possible, but no company can do it until now. mm error. Nowadays, the cutting accuracy that various machinery manufacturers can provide is generally below 0.2mm, but this cannot be just based on the introduction of the product manual. There should be a complete set of procedures for testing the cutting accuracy during acceptance, which should be based on measuring the actual cutting product accuracy. , we usually have a dozen test samples. Through testing, we can fully understand the flatness of the cutting platform and the synchronous control level of the control system, so that we can choose a suitable CNC plasma cutting machine.

Second point, cutting speed:

We can only talk about speed when the cutting accuracy is met. Since the cutting platform is short, it is difficult to judge whether the maximum speed has been reached with the eyes. We can use the software simulation function of the servo driver of the CNC plasma cutting machine to check the speed of the motor. Whether it reaches the highest level. When testing the cutting speed, do not use actual cutting and increase the acceleration and deceleration. Each axis can be tested separately or simultaneously.

In order to be able to cut perfect products, we must have a good control over the cutting accuracy and cutting speed of the gantry CNC plasma cutting machine. From the above two points, everyone must have a certain degree of understanding.