The operation and maintenance of automatic CNC plasma cutting machine and CNC fiber laser cutting machine equipment are potentially dangerous, and all personnel should take precautions to avoid injury. If the body and limbs come into contact with the moving machine, they may be injured or involved in the machine. All controls, including manual control, can be done through the keyboard or remote control interface on the front panel of the operation cabinet. Make sure that your hands do not touch the dangerous movement. machine. In addition, loose equipment, fabrics or belts may be drawn into the machine, so when operating or maintaining the machine, it is necessary to pay attention to the above items that are not worn or worn, and need to be cleaned up in time. Electric shocks or mechanical accidents can cause injury or death. This equipment must be used safely in accordance with the enclosed steps and instructions. Only specially trained operators can open this equipment. The following are exercises

Precautions for CNC plasma cutting machine and CNC fiber laser cutting machine, and the rest are electrical maintenance matters.

Before turning on the power every day:

1. Check around the machine and on both sides of the guide rail for debris, and remove all debris that affects the operation of the machine.

2. Check whether the filters of all air sources, water sources, and power sources that the machine needs to use are in normal condition.

3. Check whether the grounding related to the machine tool is loose, and whether all cable joints and sockets are in good condition.

4. It is necessary to do proper labor protection for operators.

When the CNC plasma cutting machine and CNC fiber laser cutting machine are powered on:

1. Turn on the main power first, then turn on the system power. If there is an unexpected power failure, turn off the main power switch in time. When turning on again, the system power switch should be delayed for more than 1 minute before turning on.

2. When the system is powered on, during the system startup process, do not randomly press the operation buttons on the control panel, so as to avoid unnecessary failures or accidentally enter the system maintenance menu, and cannot enter the cutting and processing operation menu normally.

3. During the boot process, there must be no disk in the floppy disk drive of the system.

During the operation and use of CNC plasma cutting machine and CNC fiber laser cutting machine:

1. The operation process should be carried out in strict accordance with the instruction manual and operation safety manual.

2. If it is necessary to input the cutting program, the disk or USB should be taken out immediately after the operation is completed, and the small door of the floppy disk drive should be closed to prevent dust and metal powder from entering the CNC system during the cutting process.

3. During the operation, the operator should be strict in labor discipline, stick to the post, pay attention to the operation of the machine at any time, and deal with it immediately in case of emergency, while reducing the failure rate and ensuring the safe operation of the equipment.

Off-duty shutdown CNC plasma cutting machine and CNC fiber laser cutting machine:

1. Return the system to the operation main menu before shutting down after get off work, raise all cutting torches to a higher position, and reset each control switch.

2. Turn off the system power first, and then turn off the main power.

3. Turn off all air, water, and power sources.

4. Keep the appearance of the machine clean and hygienic, and oil the parts of the mechanical device that need to be lubricated.